
	Products	Stock Check	Samples	Sales Reps	Distributors

Data Sheet Search by Part Number:

Stock Check by Part number:

Power Factor Correction & Surge Suppressor Support

High Temperature Film Capacitors

METALLIZED POLYPHENYLENE SULFIDE 330 SERIES

This metalized Polyphenylene Sulfide capacitor series exhibits superior electrical characteristics over an extremely wide temperature range. Their miniature size, high Q, excellent IR and capacitance stability make them ideally suited to filter network and other low-loss high frequency applications.

A wide variety of sizes and configurations are available: axial-lead wrap and fill (in oval and round shapes) and rectangular epoxy case (axial and radial leads).

All capacitors feature extended foil construction and standard Tin-Coated Copper-Clad Steel leads. Nickel, Copper, Dumet and other special leads are available.

Protective clear wrap is offered on all wrap and fill units. Please add .010" to maximum T and W or dimensions for protective clear wrap.

The potting material and endfills of electrocube's capacitors meet or exceed the flammability requirements of UL94VO.

Dimensional variations for all MFD values are available with the same volume to meet your design requirements.

Data Sheet - METALLIZED POLYPHENYLENE SULFIDE 330 SERIES

SPECIFICATIONS

Temperature:	-55ºC to +125ºC.
Dielectric Strength:	will withstand 200% at voltage and 25ºC for a period not exceed 1 minute; current limited to 5 mA.
Life Test:	will withstand 140% rated voltage for 250 hours at +125ºC With not more than 1 failure in 12 permitted. Dissipation factor: shall not exceed 0.3% at 25ºC.
Acceptance Criteria:	Measurement frequency for capacitance and dissipation factor shall be 1000Hz for values to 1 mfd; 120Hz. For values of 1 mfd and over.
Insulation Resistance:	At rated voltage or 500V, whichever is less, units shall meet the minimum values below:

Temperature (ºC)	MEG x MFDS		MEG (NEED NOT EXCEED)
	50 – 100V	200 V - UP	50 – 100V	200 V – UP
25 85 125	25,000 2,500 50	50,000 5,000 100	50,000 5,000 100	100,000 10,000 200

NOTES:
For information regarding insulating sleeves, mountings, special terminals non-standard leads, circuit connections and other hardware, please consult factory.

For styles and ratings not shown, or for unusual requirements necessitated by special circuit applications (including higher IR or lower DF), consult the factory.

All Electrocube film capacitors have endfills and tape that Meet or exceed the flammability requirements of UL94VO.

TYPICAL DIELECTRIC
CHARACTERISTIC CURVERS

site search: